Safety; Personnel Requirements; General Information - Baumer OM30 IO-Link Operating Manual

Laser distance sensor
Hide thumbs Also See for OM30 IO-Link:
Table of Contents

Advertisement

Baumer
2

Safety

2.1

Personnel requirements

Certain work with the product may only be carried out by specialized personnel.
Specialized personnel are staff members who can evaluate the tasks assigned to them and rec-
ognize potential danger, based on their training and work as well as a reliable understanding of
technical safety issues.
Qualified personnel are divided into the following categories:
Instructed personnel:
n
A person who has been informed and, if required, trained, by a specialist about the assigned
tasks and potential dangers of improper behavior.
Specialist:
n
A person who, based on his/her training, experience, and instruction, as well as his/her
knowledge of applicable standards, rules, and accident prevention regulations, has been au-
thorized to carry out the respectively required tasks, while recognizing and avoiding poten-
tial dangers.
Electrical specialist:
n
A person with the appropriate specialist training, knowledge, and experience allowing him/
her to recognize and avoid dangers originating from electricity.
2.2

General information

Intended use
This product is a precision device and serves the detection of items, objects, or physical mea-
surement variables and the preparation or provision of measured values as electric variables for
the higher-level system.
Unless specifically labeled, this product may not be used in explosive environments.
Commissioning
Assembly, installation, and calibration of this product may only be performed by a specialist.
Installation
Only use the fasteners and fastener accessories intended for this product for installation. Out-
puts not in use must not be wired. Unused wires of cable outputs must be insulated. Do not go
below the permissible cable bending radii. Disconnect the system from power before the prod-
uct is electrically connected. Use shielded cables to prevent electro-magnetic interference. If the
customer assembles plug connections on shielded cables, then EMC-version plug connections
should be used and the cable shield must be connected to the plug housing across a large sur-
face area.
Disposal (environmental protection)
V6 | OM20/OM30 IO-Link
Used electrical and electronic devices may not be disposed of in household
waste. The product contains valuable raw materials that can be recycled. There-
fore dispose of this product at the appropriate collection point. For additional in-
formation visit www.baumer.com.
Operating Manual
Safety
|
2
7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OM30 IO-Link and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents