Description - Siemens RUGGEDCOM RX1501 Installation Manual

Chapter 1
Introduction
Section 1.2

Description

The RUGGEDCOM RX1501 features various ports, controls and indicator LEDs on the front panel for connecting,
configuring and troubleshooting the device.
Figure 1: RUGGEDCOM RX1501
1. Management Port 2. RS232 Serial Console Port (DB9) 3. Utility USB Port 4. Port Status LEDs 5. Power Status LEDs 6. Alarm
Indicator LED 7. Lamp Test/Alarm Cut-Off (LT/ACO) Button 8. Compact Flash Card Port
Management Port
RS-232 Serial Console Port
Utility USB Port
Lamp Test/Alarm Cut-Off (LT/ACO) Button
Power Status LEDs
Port Status LEDs
Alarm Indicator LED
Compact Flash Card Port
2
4 6
1 2 3 5
This 10/100Base-T Ethernet port is used for system management that is out-of-band from the
switch fabric.
The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to
Use the USB port to upgrade the ROX II software or install files, such as configuration files
and feature key files. For more information, refer to the RUGGEDCOM ROX II User Guide for
the RUGGEDCOM RX1501.
This button performs two functions:
• Press and hold this button to test all indicator LEDs
• Press and release this button to acknowledge an active alarm
Indicates the status of the power modules.
• I = The power module is receiving power
• O = The power module is supplying power
Indicates when ports are active.
• Green = OK
• Orange = Warning alert
• Red = Configuration error
Indicates when an alarm condition exists.
• Green = Alarms cleared/acknowledged
• Red = Alarm
Houses the CompactFlash (CF) card that contains active and backup installations of
RUGGEDCOM ROX II, along with the configuration database and other system data. For more
information, refer to
7
8
Section 3.1, "Connecting to the
Section 3.3, "Accessing the CompactFlash
RUGGEDCOM RX1501
Installation Guide
Device".
Card".
Description