General Procedure; Unpacking The Device; Mounting The Device - Siemens RUGGEDCOM RX1501 Installation Manual

Chapter 2
Installing the Device
• Section 2.4, "Connecting the Failsafe Alarm Relay"
• Section 2.5, "Connecting Power"
Section 2.1

General Procedure

The general procedure for installing the device is as follows:
IMPORTANT!
The user is responsible for the operating environment of the device, including maintaining the integrity
of all protective conductor connections and checking equipment ratings. Make sure to review all
operating and installation instructions before commissioning or performing maintenance on the
device.
1. Review the relevant certification information for any regulatory requirements. For more information, refer to
Section 6.1, "Approvals".
2. Review the RUGGEDCOM RX1500 Series Modules Catalog for special installation or regulatory requirements
related to the modules installed in the device. In the case of cellular modem line modules, this includes
antenna installation and regulatory requirements.
3. Mount the device.
4. Connect the failsafe alarm relay.
5. Connect power to the device and ground the device to safety Earth.
6. Connect the device to the network.
7. Configure the device.
Section 2.2

Unpacking the Device

When unpacking the device, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.
Section 2.3

Mounting the Device

The RUGGEDCOM RX1501 is designed for maximum mounting and display flexibility. It can be equipped with
connectors that allow it to be installed in a 48 cm (19 in) rack, 35 mm (1.4 in) DIN rail or directly on a panel.
6
RUGGEDCOM RX1501
Installation Guide
General Procedure