Siemens RUGGEDCOM RX1501 Installation Manual page 27

RUGGEDCOM RX1501
Installation Guide
Figure 12: DC Terminal Block Wiring – European-style (Euroblock) Terminal Block for -12P, -24P and -48P Power
Supplies
1. Not Connected 2. European-style (Euroblock) Terminal Block 3. Positive (+) Terminal 4. Negative (-) Terminal 5. Ground
Terminal
Figure 13: DC Terminal Block Wiring – Screw Terminal Block for -12P, -24P and -48P Power Supplies
1. Not Connected 2. Removable Screw Terminal Block 3. Non-removable Screw Terminal Block 4. Positive (+) Terminal
5. Negative (-) Terminal 6. Ground Terminal
2. Connect the positive wire from the power source to the positive (+) terminal on the terminal block.
3. Connect the negative wire from the power source to the negative (-) terminal on the terminal block.
4. For screw terminal blocks, install the safety cover.
Connecting Low DC Power
4 1 5 1 6
2
1 2 3 4
3
Chapter 2
Installing the Device
4 5 6
17