Connecting High Ac/Dc Power - Siemens RUGGEDCOM RX1501 Installation Manual

Chapter 2
Installing the Device
Section 2.5.1

Connecting High AC/DC Power

To connect a high AC/DC power supply to the device, do the following:
DANGER!
Electrocution hazard – risk of death, serious personal injury and/or damage to the device. Make sure
the supplied cover is always installed over high voltage screw terminal blocks.
CAUTION!
Electrical hazard – risk of damage to equipment. Do not connect AC power cables to a 12, 24 or 48 VDC
power supply terminal block. Damage to the power supply may occur.
NOTE
The screw terminal block is installed using Phillips screws and compression plates, allowing either bare
wire connections or crimped terminal lugs. Use #6 size ring lugs for secure, reliable connections.
1. Connect the power supply terminal block to the device.
Figure 6: AC Terminal Block Wiring – European-style (Euroblock) Terminal Block for HIP Power Supplies
1. European-style (Euroblock) Terminal Block 2. Positive/Live (+/L) Terminal 3. Ground Terminal 4. Negative/Neutral (-/N) Terminal
12
1 2 3 4
RUGGEDCOM RX1501
Installation Guide
Connecting High AC/DC Power