Opening Doors In Preparation For Use; Figure 4-6 Example: Label With Instructions For Opening The Doors - Siemens 6SL3845-2NN41-8AD2 Operating Instructions Manual

4.4.4

Opening doors in preparation for use

NOTICE
Damage to the locking mechanism caused by incorrectly opening the doors
You can damage the locking mechanism if you open the doors incorrectly.
● When opening the doors, follow the steps described.
● If the locking mechanism is damaged it is essential that you have it repaired before
The drive is delivered in a closed state. A label showing how to open the doors in a current-free
state is located on the door.
Figure 4-6
Proceed as follows:
1. There is a screw in the door. Under the screw you will find the opening for manually opening
2. Insert a screwdriver into this opening.
3. Turn the door handle until you feel resistance.
4. Remove the screwdriver from the opening.
5. Open the doors.
SINAMICS SM150 6SL3845-2NN41-8AD2
Operating Instructions Rev.201910281310 EXAMPLE
commissioning the drive system. Contact the service center in this regard. You can find the
relevant contact person under "Service & Support".
Example: Label with instructions for opening the doors
the doors. Remove the screw.
After opening the doors, remove the label with the instructions for safety reasons. The label
is only required for opening the doors the first time.
Preparations for use
4.4 Unpacking
69