Table of Contents
Advertisement
Installation of your internal drive is now complete. Skip to page 32.
YOUR TASK:
YOUR OBJECTIVE:
YOUR METHOD:
If you are installing a single PX-R820Te and you have no other SCSI
peripherals attached to your system, you should leave the switches, dial, and
terminator found on the rear panel of your drive at their factory settings. If you
do have additional SCSI peripherals (e.g., CD-ROM, scanner, printer) attached
to your computer, you may need to change your dial and terminator settings.
See Chapters 6 and 7 for information on how to change these settings.
If you are installing a single PX-R820Te external drive, connect it as shown on
the next page.
External Drive Installation
Connect cables from your external drive to your PC
or Mac. Check to see if switch, dial, and terminator
settings need to be adjusted.
A well-functioning drive that does not conflict with
any other peripherals in your computer system.
Follow the directions below for making cable
connections. Review your current computer setup to
see if potential conflicts exist. If so, make the
necessary switch, dial, and/or terminator changes.
CHAPTER 8 — Hardware Installation
PX-R820T OPERATION MANUAL
29
Hide quick links:
Advertisement
Table of Contents
