Px-R820Te External Drive-Rear Panel - Plextor PX-R820Te Operation Manual

PX-R820Te External Drive—REAR PANEL
SCSI Interface Connector
DIP Switches: Use to select parity, termination, test, block size, or eject
lock. Leave these jumpers at their factory settings unless one or more of the
following situations pertain to you:
Termination: Review Chapter 7 to determine if you need to turn your
terminator switch OFF.
Block size: If you are working in a UNIX environment and want to boot
from your CD-R drive, see page 16.
Eject lock: If you work in an environment where you need to prevent
others from removing a CD-R disc from your drive, see page 16.
SCSI ID: Use this dial to designate SCSI ID numbers. Rotate the dial to
change the number. If you are using more than one SCSI peripheral, you
may need to change your SCSI ID number (see page 15).
Power Switch: To turn power ON/OFF.
AC Power Input: Use the power cord supplied with your drive.
Audio Output: Outputs stereo analog signal. Use to connect to soundboard
or audio amplifier. Use standard RCA jack connectors.
SCSI Interface Connector In and Out: One connector should be used to
link your CD-R drive to your SCSI host adapter; the other to link your CD-R
drive to another SCSI peripheral with a daisy chain cable (see page 31). You
may use either connector for either purpose.
CHAPTER 5 — Drive Features
DIP Switches
SCSI ID
Audio Output
Connectors
PX-R820T OPERATION MANUAL
Power Switch
AC Power Input
11