Px-R820Ti Internal Drive - Plextor PX-R820Te Operation Manual

Factory Setting of Jumper Block
The functions shown are ON if the jumpers are installed and OFF if the
jumpers are removed. The jumpers are set by the factory as follows:
Installing and Removing Jumpers
Ensure power to the drive is OFF before installing or removing jumpers.
To remove a jumper, pull it off with your fingers or a pair of needle-nose pliers.
To add a jumper, push it onto the jumper pins. Extra jumpers are supplied with
the PX-R820Ti in addition to the three jumpers already installed at the factory.
CAUTION: Install jumpers across each pin as shown. Do not connect one pin
switch to another by installing the jumpers lengthwise. Doing so
could result in damage to the drive.
Install jumpers this way
(Vertically)

PX-R820Ti Internal Drive

SCSI-ID
Jumper
CHAPTER 6 — Drive Switch/Jumper/Dial Settings
ON (Jumper installed)
TEST
PARITY
BLOCK SIZE
TERM
DO NOT install jumpers this way
(Horizontally)
PX-R820T OPERATION MANUAL
OFF (Jumper removed)
EJECT LOCK
13