Px-R820Ti Internal Drive-Rear Panel - Plextor PX-R820Te Operation Manual

CHAPTER 5 — Drive Features
ON/READ Indicator: Green when power is ON and no disc is in drive.
Green flashing when disc is being accessed.
Disc Indicator: Green when disc is in the drive and power is ON.
Volume Control: Controls volume of headphone jack. This control has no
effect on the rear panel audio outputs.
Headphone Jack: Stereo mini-jack for headphones and powered speakers.
PX-R820Ti Internal Drive—REAR PANEL
Jumpers
Audio Output Connector
Audio Output Connector: Outputs stereo analog signal. Use to connect to
soundboard or audio amplifier. Use standard MPC-3, type 4-pin connector.
Jumpers: Use to select SCSI ID number, parity, termination, or block size.
Leave these jumpers at their factory settings unless one or more of the
following situations pertain to you:
SCSI ID number: If you are using more than one SCSI peripheral, you
may have to change your SCSI ID number (see page 14).
Termination: Review Chapter 7 to determine if you need to turn your
terminator switch off.
Block size: If you are working in a UNIX environment and want to boot
from your CD-R drive, see page 15.
SCSI Interface Connector: Connects to SCSI interface board using 50-pin
to 50-pin flat ribbon SCSI cable.
Power Connector: Connects to your computer's power supply (DC +5V and
+12V).
10
PX-R820T OPERATION MANUAL
SCSI Interface Connector
Power Connector