Changing The Headlight Bulb; Checking The Headlight Setting - KTM 350 EXC-F EU 2013 Owner's Manual

14 ELECTRICAL SYSTEM
14.9

Changing the headlight bulb

Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
14.10

Checking the headlight setting

Finishing work
–
Check the headlight setting. (
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Turn rubber cap
the way and remove it.
–
Pull lamp socket
101403-10
–
Press headlight bulb
way and pull it out.
–
Insert a new headlight bulb.
Headlight (S2 / socket BA20d) (
–
Insert the rubber cap together with the lamp socket into the reflector and turn it
clockwise all the way.
Info
Ensure that the O-ring
100862-10
–
Insert the lamp socket of the parking light into the reflector.
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
p. 88)
together with the underlying lamp socket counterclockwise all
1
of the parking light out of the reflector.
2
into the lamp socket lightly, turn it counterclockwise all the
3
p. 110)
is seated properly.
4
p. 88)
under the first mark.
B
B
A
p. 87)
p. 87)
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 89)
88