Installing The Front Fender; Removing The Shock Absorber; Installing The Shock Absorber; Removing The Seat - KTM 350 EXC-F EU 2013 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.19

Installing the front fender

11.20

Removing the shock absorber

11.21

Installing the shock absorber

11.22

Removing the seat

–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate or headlight
mask.
101345-10
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
S00030-10
x
Main work
–
Push splash protector
tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
101344-11 Screw, bottom shock
absorber
Info
The heim joint for the shock absorber at the swing arm is Teflon coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101346-10
and lower the rear wheel with the swing arm as far as possible
1
, push splash protector
2 3
to the side and position the shock absorber. Mount and
1
.
2
M12
.
3
M12
.
1
.
1
M6 10 Nm (7.4 lbf ft)
p. 45)
to the side, and remove the shock
80 Nm Loctite
(59 lbf ft)
80 Nm Loctite
(59 lbf ft)
p. 45)
55
® 2701
® 2701