Installing The Fork Legs - KTM 350 EXC-F EU 2013 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.8

Installing the fork legs

(EXC‑F EU, EXC‑F AUS, XCF‑W)
–
Release screws
–
Release screws
101323-10
(EXC-F SIX DAYS)
–
Release screws
–
Release screws
B01227-10
x
Main work
(EXC‑F EU, EXC‑F AUS, XCF‑W)
–
Position the fork legs.
101325-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
101323-11
(EXC-F SIX DAYS)
–
Position the fork legs.
B01239-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B01227-11
. Take out the left fork leg.
4
. Take out the right fork leg.
5
. Take out the left fork leg.
4
. Take out the right fork leg.
5
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
Position bleeder screws toward the front.
1
.
2
.
3
Info
The rebound damping is located in the right fork leg (red adjusting
screw). The compression damping is located in the left fork leg (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
Position bleeder screws toward the front.
1
.
2
.
3
M8 20 Nm
(14.8 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M8 17 Nm
(12.5 lbf ft)
M8 12 Nm
(8.9 lbf ft)
47