Subscribe to Our Youtube Channel
Related Manuals for Clarke RANGER 45
Summary of Contents for Clarke RANGER 45
- Page 1 RANGER 45 / 65 RANGER 45 / 65 AIR COMPRESSOR AIR COMPRESSOR OPERATION & MAINTENANCE INSTRUCTIONS © 0806...
- Page 2 Please note that the details and specifications contained herein, are correct at the time of going to with the lowest possible atomizing air pressure. print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machine’s data plate When disposing of this product, ensure it is disposed of according to all local ordinances 4.
-
Page 3: Table Of Contents
PAINT SPRAYING HINTS WARNING NEVER attempt to spray unless you are wearing suitable, approved Thank you for purchasing this CLARKE RANGER Air Compressor, which is designed respiratory and eye protection. for indoor hobby and DIY use only. REMEMBER that some modern paints require specialist respiratory Please read this leaflet thoroughly and carefully follow all instructions. -
Page 4: Safety Precautions
DO NOT leave pressure in the receiver overnight, or when transporting. Consult your Clarke dealer - A Quick Fit Nut is required in order to attach the hose. DO NOT adjust, or tamper with the safety valves. The maximum pressure is factory set, and clearly marked on the machine. -
Page 5: Assembly
Screw on the air filter assembly fully - Fig.2. Fig.3 Remove the plastic Travel Plug from the breather orifice (‘B’ Fig.3) and fill the compressor with Clarke compressor oil (see Specifications), to the centre of the oil sight glass ‘A’ Fig.3, then screw in the breather, ‘B’... -
Page 6: Electrical Connections
PARTS LIST ELECTRICAL CONNECTIONS No. Description Qty Part No. No. Description Qty Part No. Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator Hex Skt Hd Bolt M6x55 4 HTRANG001 45 Washer 1 HTRANG045 Spring Washer... -
Page 7: Operation
CAUTION Do not attempt any repair or adjustment if you are uncertain as to how Now connect a suitable air hose, with a 1/4 BSP connector, between the air outlet it should be done. If you have any queries, contact your local CLARKE Dealer. (H) and the spray gun or air tool being used. -
Page 8: Routine Maintenance
If the motor fails to necessitating its dismantling and replacement parts etc. start, after several attempts, consult your Clarke dealer. BEFORE EACH USE Once the machine has started, turn ON the air supply to your air tool by opening...
Need help?
Do you have a question about the RANGER 45 and is the answer not in the manual?
Questions and answers