Table of Contents
Advertisement
44
Installing the PCX Windows 2000 Driver
Before you install the DOME Windows 2000 driver, make
sure these components are installed on your system:
• Windows 2000 operating system
• DOME board capable of supporting VGA display or any
VGA board
Only system administrators should perform the driver
installation procedures described in this section.
Install all DOME boards before you install the driver.
See "To install the board" on page 15 for instructions.
Then reboot your system and install the driver for each
board individually. See "To install the driver" on page 45
for instructions.
To support multiple DOME screens
1. Install the DOME driver for the board to enable a single
display driven by the board.
2. Reinstall the DOME driver for each additional display
(sister display) driven by the board. See "To enable the
sister display" on page 48.
3. Extend the Windows 2000 desktop settings for the first
DOME screen onto the sister display. See "To set the
resolution and refresh rate for the sister display" on
page 49.
You must reinstall the driver for each Md4/PCX
board installed in your system, otherwise the driver
may malfunction.
Chapter 2
Advertisement
Table of Contents
