Advertisement
User Manual
Connectors
Transmitter Input: 4 x HDMI Type A (Female)
Transmitter Output: 4 x HDMI Type A (Female), 4 x RJ-45 (Female), 4 x 3.5mm IR (Female), RJ-45
LAN Control (Female), 3-Pin Phoenix Connector (Female)
Receiver Input: RJ-45 (Female), 3.5mm IR (Female)
Receiver Output: HDMI Type A (Female)
Product Overview
Matrix Unit
Front Panel
Power Switch: Push the switch to power the matrix on or off.
Power LED: The LED will illuminate green once powered on.
IR: IR receiver eye for control from the IR remote.
Output 1 – 4 Push Buttons & HDMI Source LED: Push the Output 1 – 4 button the select the HDMI
Input connection for the corresponding output port. The corresponding input LED will illuminate.
Rear Panel
LAN: Connect to an active Ethernet connection with a Cat.6 cable for IP control.
RS-232: Connect to a PC or control system with the 9-pin RS-232 cable for RS-232 command control.
HDMI Output 1 – 4: Connect to a HDMI display using HDMI cable.
Cat Output 1 – 4: Connect to the Cat In Port of the receiver using Cat.6 or above cable.
IR Out 1 – 4: Connect the IR emitter cable for control from the receiver side of the installation using
the IR receiver cables.
HDMI In 1 – 4: Connect to an HDMI source device with an HDMI cable.
12VDC: Connect the 12V 1.25A Power Supply.
Receiver
HDMI Out: Connect to an HDMI display using HDMI cable.
Cat In: Connect to the Cat Out port of the matrix using Cat/6 or above cable.
Service: Reserved for Firmware Updates.
IR In: Connect the IR Receiver cable to control the source side of the installation.
12VDC: Connect a 12V 1.25A Power Supply. Please note the receiver can also be powered by the
matrix using PoC (Power over Cable).
English
Advertisement
