Advertisement
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether all
parts and accessories are included.
ITEM DESCRIPTION
A
Pocket hole jig
B
Dust collector adapter
C
3/8" drill bit
D
R2 driver bit
E
Hex key
F
3/8" stop collar
Figure 1
B
A
C
WARNING
The pocket hole jig is completely assembled. Before using make
sure you have read and understood this entire operating manual
and the operating manual of the drill being used.
DUST COLLECTOR ADAPTER
The pocket hole jig is equipped with a dust collector adapter, it
can be used with or without the adapter.
1.
Snap the dust collector adapter onto the top of the pocket
hole jig.
2.
Connect it to a dust extractor or dust collector.
3.
Adjust the dust collector adapter to the needed position, it
can be rotated over 180°.
Figure 2
F
E
D
Dust Collector Adapter
SET UP - TO DRILL POCKET HOLES
1.
Measure your material thickness.
2.
On the side of the pocket jig is a material thickness
alignment mark and measurements. Slide the body of the jig
in or out to align the alignment mark with the measurement
QTY
of the material thickness. The mark is aligned to 3/4"
1
material thickness in Figure 3.
Figure 3
1
1
1
1
1
3.
Turn the pocket hole jig over to set the drill depth position.
a.
Slide the 3/8" stop collar on to the 3/8" drill bit. Do not
tighten.
b.
Slide the drill bit into the pocket hole jig and align the
second step of the drill bit with the scale mark.
-
The thickness of the material is less than 7/8",
aligned with the first mark
-
Material thickness is 1" – 1‑1/8", align with the
second mark
-
Material thickness is greater than 1‑1/4", align with
the third mark
c.
Slide the 3/8" stop collar to the edge of pocket hole jig
and tighten the screws on the stop collar with the hex
key (provided).
Figure 4
1st
2nd
3rd
Mark
Mark
Mark
3/8" Drill Bit shown aligned to the first mark
(material thickness is less than 7/8")
DRILLING POCKET HOLES
1.
Position the pocket hole jig in place and clamp it to
the workpiece.
-
Place pocket holes 5/8" to 1‑1/2" from the edge and
every 6" to 8" apart.
-
If not using the dust collector adapter, DO NOT block
the chip ejection holes.
-
There are three alignment marks on the front of the
jig. The middle line aligns to the center between the
two holes to be drilled. The two side lines align to the
center of the two holes to be drilled.
Material Thickness
Alignment Mark to 3/4"
Material Thickness
Measurements
Edge of Pocket Hole Jig
3/8" Stop Collar
Advertisement
