Advertisement
DRIVE POCKET HOLE SCREWS
Reference the Recommended Screw Length chart for the
1.
correct screw length for the material thickness used.
Recommended Screw Length
Material Thickness
1/2"
5/8"
3/4"
7/8"
1"
1‑1/8"
1‑1/4"
1‑3/8"
1‑1/2"
* Panhead pocket screws are recommended.
NOTE: Screw length is measured from the bottom of the
head to the tip of the screw.
1"
2.
Use the R2 driver bit (supplied) to drive the wood screws
into the material.
Figure 10
Square‑Drive Head Screw
Screw Length
1" *
1"
*
1‑1/4"
1‑1/2"
1‑1/2"
1‑1/2"
2"
2"
2‑1/2"
R2 Driver Bit
Visit us on the web at www.
Put these instructions and the original sales invoice in a safe,
dry place for future reference.
Southern Technologies, LLC
Chicago, IL 60606
GENERAL MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage. To
ensure safety and reliability, all repairs should be performed by a
qualified service technician.
WARNING
Keep the pocket hole jig dry, clean, and free from oil and grease.
Always use a clean cloth when cleaning. Never use brake fluids,
gasoline, petroleum based products or any strong solvent to
clean the pocket hole jig. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
powertecproducts.com
Advertisement
