Planar Dome E2 Quick Reference Manual page 7

Installing the DX Display Driver
Before you install the driver, remove any previously installed display driver from
your system.
To install the driver
1 Log on with administrator privileges. The InstallShield Wizard reports
new hardware.
2 Click Cancel. You must run Setup.exe to install the driver.
3 Insert the W2KDXPCI CD and open the CD folder.
4 Double-click Setup.exe.
5 Click Next to proceed and start copying fi les.
6 If the Digital Signature Not Found message appears, click Yes or Continue to
complete the driver installation.
7 Select Yes, I want to restart my computer now, and click Finish.
To enable the display
1 Log on with administrator priviledges.
2 Right-click the desktop. Select Properties > Settings.
3 Select the display icon.
4 Select Extend my Windows desktop onto this monitor. Click Apply.
5 Click OK.
To change the display properties
Use the Dome tab to change display properties after the Dome EX display is
attached to the Windows desktop. Otherwise, use Properties > Settings tab.
7