ESAB Warrior 400i CC/CV Instruction Manual page 14

4 INSTALLATION
NOTE!
This power source version is designed for a nominal input voltage from 380 to 415 V
AC. ESAB does not recommend a connection of the cable on the circuit board in the
position of 440 , 460 or 575 V AC.
If the mains cable needs to be changed, the earth connection to the bottom plate and the
ferrites must be installed correctly. See the picture below for the installation order of the
ferrites, washers, nuts and screws.
0463 362 201 - 14 - © ESAB AB 2022