Installing The Processor Heatsink Module (Phm) - Supermicro SuperWorkstation SYS-740A-T User Manual

Installing the Processor Heatsink Module (PHM)

1. Align peek nut "A", which is next to the triangle (Pin 1) on the heatsink, against threaded
fastener "a" on the CPU socket. Then align peek nuts "B", "C", "D" on the heatsink
against threaded fasteners "b", "c", "d" on the CPU socket, making sure that all peek
nuts on the heatsink are properly aligned with the correspondent threaded fasteners on
the CPU socket.
2. Once they are aligned, gently place the heatsink on top the CPU socket, making sure
that each peek nut is properly attached to its corresponding threaded fastener.
3. Press all four rotating wires outwards and make sure that the heatsink is securely
latched unto the CPU socket.
Chapter 3: Maintenance and Component Installation
A, B, C, D:
Peek Nut on the Heat-
sink
B
D
A
b
d
a
a, b, c, d:
Threaded Fastener on the CPU socket
Rotating Wire
48
C
c
Rotating Wire