Vertiv 582127000500 Installation Manual page 66

Vertiv™ NetSure™ 7100 Series -48 VDC Power System Installation Manual
Web Menu Navigation:
Settings Menu / Battery Tab / Reset Battery Capacity.
Refer to the NCU Instructions (UM1M830BNA) for detailed instructions.
Configuring the NCU Identification of Rectifiers and
Assigning which Input Feed is Connected to the Rectifiers (Optional)
When rectifiers are all installed prior to applying power and starting the system, the order in which the NCU identifies the rectifiers is
by serial number (lowest serial number is Rect 1, next lowest is Rect 2, etc.). If you prefer the NCU to identify the rectifiers by position
in the system, perform the following procedure.
Upon power up, the NCU arbitrarily assigns Feed AC1, AC2, or AC3 to each rectifier. This assignment is used to display rectifier AC
input feed voltage(s). The User may reassign the feed to each rectifier per your specific installation by following the procedure below.
Local Menu Navigation:
None.
Web Menu Navigation:
Refer to the NCU Instructions (UM1M830BNA) for detailed instructions.
Configuring the NCU Identification of Converters (Optional)
When converters are all installed prior to applying power and starting the system, the order in which the NCU identifies the converters
is by serial number (lowest serial number is Conv 1, next lowest is Conv 2, etc.). If you prefer the NCU to identify the converters by
position in the system, perform the following procedure.
Local Menu Navigation:
None.
Web Menu Navigation:
Refer to the NCU Instructions (UM1M830BNA) for detailed instructions.
NCU Alarm Relay Check
To verify operation of the external alarm relays, use the NCU alarm relay test feature. Refer to the NCU Instructions (UM1M830BNA)
for instructions in using this feature.
NOTE!
The relays may be preprogrammed for specific functions. Refer to the configuration drawing (C-drawing) supplied
with your system for your system's specific configuration.
60 Proprietary and Confidential © 2022 Vertiv Group Corp.