Cleaning The Coffee Spouts; Cleaning The Pre-Ground Coffee Funnel; Cleaning The Infuser; Cleaning The Milk Container - DeLonghi ETAM36.36 Series Instructions For Use Manual

3. Replace the filter (if provided), fill the tank with fresh
water and replace the tank;
4. (Models with water softener filter only) Deliver about 100
ml of hot water to reactivate the filter.

12.7 Cleaning the coffee spouts

1. Clean the coffee spouts (A11) regularly with a sponge or
cloth (fig. 32);
2. Check that the holes in the coffee spouts (A11) are not
blocked. If necessary, remove coffee deposits with a tooth-
pick (fig. 33).

12.8 Cleaning the pre-ground coffee funnel

Check regularly (about once a month) that the pre-ground
coffee funnel (A4) is not blocked. If necessary, remove coffee
deposits with the brush (C5) supplied.

12.9 Cleaning the infuser

The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see section
"7. Turning the appliance off");
2. Open the infuser door (A21) (fig. 34) on the right side of
the appliance;
34
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 35);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
35
36
37.
37
38

12.10 Cleaning the milk container

Clean the milk container (D) each time you prepare milk as de-
scribed below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 39);
39
3. Turn the froth adjustment dial anticlockwise to the "IN-
SERT" position (fig. 39) and pull off upwards;
38
7. After cleaning, replace the
infuser by sliding it onto the
internal support (fig. 36),
then push the PUSH symbol
fully in until it clicks into
place;
Please note!
If the infuser is difficult to in-
sert, before insertion, adapt
it to the right size by pressing
the two levers shown in fig.
8. Once inserted, make
sure the two coloured
buttons have snapped
out (fig. 38);
9. Close the infuser door.