Table of Contents
Advertisement
If the coffee is delivered too slowly or
not at all, turn one click clockwise to-
wards "7".
For fuller bodied creamier coffee, turn
one click anticlockwise towards "1" (do
not turn more than one click at a time
otherwise the coffee could be delivered a drop at a time).
These adjustments will only be evident after at least 2 cups of
coffee have been delivered. If this adjustment does not obtain
the desired result, turn the dial another click.
9.5 Tips for a hotter coffee
For hotter coffee, you should:
•
perform a rinse cycle by selecting the "Rinse" function in
the settings menu (see section "8.1 Rinsing");
•
warm the cups with hot water (using the hot water
function);
•
set a hotter coffee temperature in the settings menu (see
section "8.10 Setting the temperature");
•
press the
button (A24) to enable the cup warmer
shelf (A10) (the
9.6 Making coffee using coffee beans
Important!
Do not use caramelised or candied coffee beans as they could
stick to the coffee mill and make it unusable.
1. Fill the container (A2) (fig. 14) with coffee beans;
2. Place under the coffee spouts (A11):
- 1 cup, if you want to make 1 coffee (fig. 15);
- 2 cups, if you want 2 coffees (fig. 17);
3. Lower the spouts as near as possible to the cup (fig. 16).
This makes a creamier coffee;
4. Press the button corresponding to the number of coffees
required (
B6 for 1 cup, or
5. Preparation begins. The amount of coffee selected appears
on the display (B4) together with a progress bar which
gradually fills as preparation progresses.
Please note:
•
While the machine is making coffee, delivery can be inter-
rupted at any moment by pressing any button.
•
At the end of delivery, to increase the quantity of coffee in
the cup, just press and hold (within 3 seconds) one of the
coffee buttons (
Once the coffee has been made, the appliance is ready to make
the next drink.
Please note!
symbol appears on the display, B4).
B7 for 2 cups);
or
).
•
Various alarm messages could be displayed while using the
appliance (fill tank, empty grounds container, etc.). Their
meaning is explained in section "18. Displayed messages";
•
For hotter coffee, see the section "Tips for a hotter coffee";
•
If the coffee is delivered a drop at a time, too weak and
not creamy enough or too cold, read the tips in the section
"Troubleshooting".
9.7 Making coffee using pre-ground coffee
Important!
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
•
Never use more than 1 level measure (C2) or it could dirty
the inside of the coffee machine or block the funnel (A4).
Please note!
If you use pre-ground coffee, you can only make one cup of
coffee at a time.
1. Press the
appears on the display (B4).
2. Open the top lid (A1), then open and raise the pre-ground
coffee funnel lid (A3).
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coffee (fig. 18).
4. Place a cup under the coffee spouts ( fig. 16).
5. Press the 1 cup coffee button
6. Preparation begins. The amount of coffee selected is dis-
played together with a progress bar which gradually fills as
preparation progresses.
Please note!
If "Energy Saving" mode is active, you may have to wait a few
seconds before the first coffee is delivered.
10. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES
Please note!
•
To avoid producing milk with poor froth or large bubbles,
always clean the milk container lid (B12) and hot water
connection nozzle (D2) as described in sections "10.4
Cleaning the milk container using CLEAN", "12.10 Cleaning
the milk container" and "12.11 Cleaning the hot water/
steam connection nozzle".
10.1 Filling and attaching the milk container
1. Remove the lid (D2) by pressing the lid extraction button
(D6) and at the same time lifting the lid upwards (fig. 19);
2. Fill the milk container (D3) with a sufficient quantity of
milk, not exceeding the MAX level marked on the contain-
34
button (B1) (fig. 10) until "Pre-ground"
(B6) (fig. 15).
Advertisement
Chapters
Table of Contents
Troubleshooting
