Table of Contents
Advertisement
9.4.11
Valve on tank assembly
1. Lubricate the seals with approved silicone grease.
2. Spin the valve (1) onto the tank (2), ensuring the threads are not cross-threaded.
3. Rotate the valve (1) clockwise and freely, without using force until it comes to a stop.
Info
This stop position is considered point zero.
4. Rotate the valve (1) clockwise from point zero to between ¼ turn and ½ turn.
Caution - material
Risk of damage due to excessive force !
Do NOT exceed 27 Nm of torque when installing the valve. Exceeding this limit may
damage the threads and cause failure.
Point 0
Ref. MKT-IM-026 / C - 15.12.2020
Installer manual Fleck 2750 NXT/NXT2 - Maintenance
¼ turn
Point 0
½ turn
151 / 170
Advertisement
Table of Contents
