Table of Contents
Advertisement
1. Set the maximum flow rate with
2. Press
to validate the selection and advance to the next
parameter.
3. Set the number of litres per pulse(s) with
4. Press
to validate the selection and advance to the next
parameter.
5. Set the number of pulses for the programmed number of litres
with
,
and
6. Press
to validate the selection and advance to the next
parameter.
6.1.5.21 Parameters saving
Info
When the last parameter is set and the button
database based on the new programming.
Wait until programming is finished, this may take a few seconds.
6.1.6
Diagnostic
6.1.6.1
Commands
Info
Depending on current settings, some displays cannot be viewed and there is no time
limit on the displays in the Diagnostic mode.
1. Press D to enter the Diagnostic mode.
2. Press
to pass at the next step.
3. Press D to exit the Diagnostic mode at any time.
6.1.6.2
Current flow rate
Info
The display is updated every second.
Ref. MKT-IM-026 / C - 15.12.2020
,
and
.
Installer manual Fleck 2750 NXT/NXT2 - Programming
.
Example: 290 L/min.
,
and
.
Example: 1 litre for 1 pulse.
Example: 5 litres for 1 pulse.
Example: 2 litres for
10 pulses.
pressed, the controller updates the
81 / 170
Advertisement
Table of Contents
