Table of Contents
Advertisement
Installation
Analog cordless 1-line/2-line - CTM-A2411-BATT/CTM-A2421-BATT
Installation option - converting from desktop to wall mount position
To mount the telephone base on the wall:
1. Unplug the power adapter and telephone line cord. Disconnect the power cord from the telephone base.
2. Set aside the handset. On the telephone base cradle, place a coin in the slit of the wall mount clip and rotate a half turn
(180 degrees). It locks into place with the protruding edge pointing towards the upper edge of the telephone base. This
protruding edge holds the handset when the phone is mounted on the wall.
3. Turn the telephone base over with the bottom side facing up. To remove the mounting bracket, firmly push both tabs downward
and pull up until both tabs release from the grooves.
4. Mount the telephone base on
base down on both mounting studs until it locks into place.
5. Connect the power cord to the telephone base. Plug the power adapter into an electrical outlet not controlled by a wall switch,
and plug the telephone line cord into the telephone wall jack. Then place the cordless handset on the telephone base cradle.
Mounting
bracket
the wall by aligning the eyelets with the mounting studs of the wall plate.
Eyelets
Protruding edge
35
Then slide the telephone
Advertisement
Table of Contents
