Download Print this page

Pioneer WYF-25 Series Installation & User Manual page 7

Ductless mini split system air conditioner / heat pump

Advertisement

Included Accessories
Accessories and Components:
The air conditioning system comes with the following accessories (the asterisk items are sold
separately). Use all of the installation parts/accessories to install the air conditioner. Improper
installation may cause the equipment to fail, or result in water leakage, electrical shock, or fire.
Name
1x
Installation and Owner's Manual
1x
Warranty Card
1x
Communication/Signal Cable*
1x
Insulated Copper Pipe Set*
1x
Remote Controller
1x
Remote Controller Holder
2x
Remote Controller Batteries
Appearance
1x
Indoor Unit Mounting Plate
SPLIT-TYPE ROOM AIR CONDITIONER
(Pre-attached to air handler rear)
Installation and
Owner's Manual
1x
Set of Mounting Plate Screws
CS78421-548-754
IMPORTANT NOTE:
Read this manual carefully before installing
or operating your new air conditioning
unit. Make sure to save this manual for
future reference.
1x
Plastic Drain Joint Plug
LIMITED PARTS WARRANTY
Pioneer® Brand Split System Heat Pump Products
© 2023, PARKER DAVIS HVAC INTERNATIONAL INC.
1. Unless this high quality product is registered properly as soon as it is put in service, all references made in this document to the term "warranty" solely refer
to the Basic Warranty, as further de ned below. If this high quality product is registered properly as soon as it is put in service, all references made in
this document to the term "warranty" refer to the Standard Warranty, also as further de ned below.
2. Warranty is provided by Parker Davis HVAC International, Inc. (hereinafter referred to as PD), the supplier of Pioneer® branded Split System Heat
Pump Products (hereinafter referred to as Products), covering all parts of the Products, subject to the following details:
a. Types of Installations: Warranty applies to all Products, installed in a residence. Warranty also applies to Products classi ed as light
commercial Products, installed in commercial properties.
b. Product Registration: Registration is not required for the availability of the Basic Warranty. Warranty registration is strongly urged and required
for the validity of the Standard Warranty. To register the Product, within one week after the Product is properly installed, ll out the warranty
registration card packed with the Product and send it in as instructed in the form OR conveniently register online at www.pdhvac.com and use the
registration link.
c. Exclusions to Warranty Coverage: Warranty does not apply to any Product that:
i. Are installed outside the United States of America.
ii. Are operated in unoccupied structures or used for purposes other than comfort cooling / heating.
iii. Are residential Products, but installed or used for commercial purposes.
iv. Has been removed from the place it was originally installed and reinstalled at another place.
d. Warranty Coverage: The warranty covers the parts of the Products, which may become defective due to the quality of the materials or
workmanship, under normal use and proper maintenance.
e. Warranty Does not Cover: PD is not responsible for any warranty claim due to:
i. Damages or repairs arising as a result of a faulty installation or wrong application.
ii. Damages or repairs arising from any external perils, out of PD's control, such as res, storms, accidents, oods, broken or frozen water
pipes, electrical surges, input power with under or overvoltage, lightening or existence of corrosive substances nearby.
iii. Damages or repairs arising from use of non-compatible parts, alterations, modi cations or improper applications.
1x
Condensate Drain Hose*
iv. Necessary maintenance required for the proper operation of the equipment, such as cleaning of all air lters, heat exchangers, fans and
blowers, any necessary lubrication of internal components and maintenance of external accessories.
v. Damages or repairs needed because of using parts, supplies or other add-on components that are not supplied by or approved for use by
PD.
vi. Damages or repairs as a result of improper use, poor maintenance, wrong operation or improper service.
vii. Changes that can be considered cosmetic, not a ecting the systems performance, including but not limited to small n damages.
viii. Resetting of power or the circuit breakers and replacement of other types of fuses, both internal and external.
ix. Any damages of repairs caused by the use of dirty, recycled, wrong type or unapproved refrigerants and lubricants.
x. Damages or repairs due to moisture, air, dust, sand, dirt, etc., that have been allowed into the system by improper handling of system parts
and components during installation.
xi. Damages or repairs caused by continuing use the Product, after a malfunction has been noticed or indicated at the display module,
through an error code.
xii. Damages or performance issues due to improper matching, Product selection, under-sizing, over-sizing, improper installation or misuse.
f. Warranty Begin Date: Warranty begins on the date of installation and commissioning of the Product, in existing residences and commercial
buildings and on the date of sale of the dwelling, for the new residential construction to the rst buyer. However, the warranty beginning date cannot
exceed a date, further than 6 months following the manufacturing date of the Product as coded in the serial number. Warranty is provided only to the
rst original owner of the Product, where it is originally installed, and is not transferable to the subsequent owners.
g. Warranty End Date: Products that have not been registered as instructed above are covered under the Basic Warranty. The Basic Warranty lasts
for a period of up to one year. Products that have been properly registered as instructed above will be covered under Standard Warranty. The
Standard Warranty lasts for a period of up to ve years as further explained below in detail and only as long as the original registered owner, own
and reside in the dwelling, or operate the business in the property, in which the Product had been originally installed.
h. Remaining Warranty: Any part, component or Product that was replaced under the terms of the warranty will be covered under the same
warranty and only for the duration in which the original warranty for the Product is applicable, as commenced on its begin date.
i. Warranty Procedure: PD will furnish a new or remanufactured replacement part, without any charge for the part itself, for the replacement of any
part that has been determined to have failed, by PD at its sole discretion, due to defects in its materials or workmanship under standard use and
proper maintenance. Associated shipping costs for the replacement parts may also be covered at PD's expense, at its own discretion and under
certain conditions, while the shipping method used will be solely determined by PD. Otherwise, the payment of the shipping costs for the part will be
the sole responsibility of the owner of the Product. PD reserves the right to ask the owner of the Product to return the failed part to PD, before
or after a replacement part may be sent out.
j. Labor cost, materials and other costs: Any labor costs and/or the costs for the supplies or materials used or purchased in the eld for the
replacement of the defective part, remain the responsibility of the owner. No other costs, involved in diagnosis, lodging, transportation, servicing, repair,
replacement, installation, removal, shipping, etc., are to be covered under the warranty.
k. Refrigerant: Any costs related to charging, recharging, adjustment, or removal of the refrigerant, and the cost of the refrigerant itself, are not
covered under any circumstances. All Products go through vigorous quality controls at various stations and leave the factory in perfect working
and sealed condition. Products are individually tested in highly sensitive helium vacuum chambers for existence of refrigerant leaks. Therefore PD
does not cover any claims related to the lack of refrigerant in new Products, discovered upon arrival, or during installation, as well as subsequent
refrigerant losses occurring at any time afterward
1x
Wrapping Tape*
1x
Wall-Hole Packing Sealant*
1x
Wall Sleeve*
*Items with an asterisk may be sold separately and are sometimes supplied by the installer. Therefore some
items may di er in appearance, shape, or length, depending on what was chosen to be used for the
TEMP
installation. Di erent scenarios, be sure to select the components that are suitable for your application.
BTU Capacity
9000
12000
18000
24000
Name
Connecting Pipe Diameters
Gas Line
3/8"
1/2"
5/8"
2
Appearance
Liquid Line
1/4"
1/4"
3/8"
Page 7

Advertisement

loading