Advertisement
Operating Instructions
Changing the Fan Speed in Cool/Heat Modes
The fan speed can be changed between AUTO, HIGHER,
HIGH, MEDIUM, LOW, and LOWER speeds in Cool/Heat.
To do so, press the
then be set. It follows the cycle of:
Auto
Higher
High
Medium
Turning the Display On or Off
The LED display on the front panel of the
system can be turned on or off as desired.
To do so, press the
switch off the LED display on the front panel.
This button can be pressed again to turn the
LED display back on.
SLEEP Mode
SLEEP mode is generally meant for periods of lower
cooling requirements, such as during typical sleeping
hours. This mode will result in decreased energy use,
and can only be activated in Cool, Heat, or Dry modes.
Fan speed is automatically set to LOW. After 8 hours in
SLEEP mode, the air conditioner will stop operation.
To put the system into SLEEP mode, press the
button, and the
symbols will appear on the
remote's display in the following sequence:
The table to the right outlines the operational logic of
the four different SLEEP mode settings.
button. The running fan speed can
Low
Lower
button in order to
OFF
Target Temp. Increase/Decrease
Sleep
Operation
After 1, 2, 6, or 7 hours
Mode
Mode
2 Hours 6 Hours 7 Hours
1 Hour
-
Mode 1
+
2°F
Cool/Dry
-
–
Heat
2°F
-
+
2°F
Mode 2
Cool/Dry
-
–
Heat
2°F
Mode 3
+
1°F
+
2°F
Cool/Dry
–
2°F
–
2°F
Heat
Mode 4
Cool/Dry
No Change - Turns off after 8 hours
Heat
No Change - Turns off after 8 hours
4
TEMP
TEMP
-
-
-
-
–
–
1°F
1°F
+
1°F
+
1°F
–
2°F
–
1°F
+
2°F
+
2°F
Page 15
Advertisement
