Danfoss iC7 Series Installation Manual page 7

In-bottom/Out-top Cooling Kit for FA11-FA12
Installation Guide
Illustration 5: Dimensions of Vent in Top of Frequency Converter
48 (1.9)
159 (6.2)
3 (0.1)
6X 6 (0.2)
Illustration 6: Dimensions for Opening in Cabinet Top Plate
2.5 Assembling the Ducts
The top and bottom ducts are telescopic ducts that collapse to simplify installation. To assemble the ducts before installation, use
the following steps. Refer to
Procedure
1.
Cut the strip of ribbed EPDM rubber seal into 4 pieces. Cut 2 strips of 1027 mm (40.4 in) for the top duct, and 2 strips of 990
mm (39.0 in) for the bottom duct.
2. Peel the paper off the self-adhesive seals. Place 1 strip on the outside bottom edge of the inner sleeve of each duct, and 1
strip on the upper inside edge of the outer sleeve of each duct.
Danfoss A/S © 2022.12
378 (14.9)
378 (14.9)
160 (6.3) 160 (6.3)
0.0
Illustration 7.
81 (3.2)
131 (5.2)
62 (2.4)
131 (5.2)
Installation
AN361429548582en-000201 / 136R0255 | 7