Danfoss iC7 Series Installation Manual page 6

In-bottom/Out-top Cooling Kit for FA11-FA12
Installation Guide
699 (27.5)
0.0
254 (10.0)
263 (10.4)
0.0
Illustration 4: Mounting Plate in 800 mm (32 in) Cabinet
2.4 Creating a Vent Opening in the Top Plate
To create a vent opening in the cabinet top plate, use the following steps. Refer to
Procedure
1. Cut out the vent opening in the cabinet top plate using the dimensions in the template.
The opening must match the frequency converter vent opening.
2. Drill 6 screw holes (6 mm) around the vent opening suing the dimensions in the template.
The holes must match the holes in the upper flange of the top duct.
6 | Danfoss A/S © 2022.12
254 (10.0)
6X S-M10-2ZI
1545 (60.1)
251 (9.9)
263 (10.4)
23 (0.9)
Illustration 5
Installation
and Illustration 6.
AN361429548582en-000201 / 136R0255