Danfoss iC7 Series Installation Manual page 5

In-bottom/Out-top Cooling Kit for FA11-FA12
Installation Guide
2.3 Preparing the Mounting Plate
To create holes in the mounting plate, use the following steps. Use the dimensions in
in Illustration 4 for 800 mm (32 in) cabinets.
Procedure
1.
Drill 6 holes in the mounting plate using the dimensions in the template.
The holes must match the holes in the frequency converter.
2.
Insert 6 M10 pem self-clinching nuts (not supplied) in the mounting holes.
499 (19.6)
0.0
206 (8.1)
215 (8.5)
0.0
Illustration 3: Mounting Plate in 600 mm (24 in) Cabinet
Danfoss A/S © 2022.12
206 (8.1)
23 (0.9)
6X S-M10-2ZI
1545 (60.1)
251 (9.9)
215 (8.5)
Illustration 3 for 600 mm (24 in) cabinets, and
AN361429548582en-000201 / 136R0255 | 5
Installation