Power Pwr/Io Connector; Pwr / Io Connector; Circuit Example - Connection Of Power Supply; Connection Of Pwr / Io Connector - Advantech SmartStart SL306 User Manual

5.8.2 Power PWR/IO Connector

Panel socket 4-pin.
Pin number Signal mark
1 GND(-)
2 VCC(+)
3 IN0
4 OUT0
Unit has to be supplied by a power supply specified as a Limited Power Source (LPS)
according to Annex Q of IEC 62368-1:2014. If the power supply/cable provided with
device is not used, always use the cables with minimum wire size (nominal cross section)
0.5 square mm for power supply.
The power supply for the router must be between +9 V to +36 V DC, with current output
1 A. Protection against reversed polarity without signaling is built into the router. Note: The
protection against reversed polarity is lost if the negative pole is grounded!
The router is awakened after the power supply outage and subsequent renewal.
Figure 17: Circuit example – connection of power supply
The PWR / IO interface is also designed for the processing of binary input and control
(setting) of binary output.
Description
Negative pole of DC supply voltage
Positive pole of DC supply voltage (+9 to +36 V DC, 1 A)
Binary input
Binary output
Table 6: Connection of PWR / IO connector
Figure 16: PWR / IO connector
17
SmartStart SL306