Storage - Woods BATWING BW20.51Q Operator's Manual

Lock-Up
Always transport with wings and center frame in the
raised, locked position.
Wing Lock-Up
Pin Storage
DP2 Postion
Figure 2. Transport Lock-Up
Wing and Center Section Shown
1. Remove safety pin and lock-up pin from storage
position.
2. Raise wing and align wing transport lock with slotted
holes in the cylinder lugs.
3. Insert lock-up pin above cylinder pin and secure
with klik pin
4. Repeat steps 1 to 3 for opposite wing.
5. Relieve hydraulic pressure from wing cylinders and
lower wing against wing transport lock.
Center Section Lock-Up
Figure 3. Transport Lock In Operation Position
18 Operation
MAN1282_2023-04.indd 18 MAN1282_2023-04.indd 18
1. Raise cutter with hydraulic cylinder to maximum
height.
2. Rotate transport lock into position over cylinder rod
(Figure 2).
3. Lower cutter against transport lock.
4. To lower cutter for operation, extend hydraulic cylin-
der to raise cutter. Rotate transport lock back away
from cylinder rod (Figure 3).
5. Lower cutter to cutting height. Use cylinder stops
(stroke control kit) to set desired cutting height.

STORAGE

Follow these steps when storing your cutter:
1. Clean cutter before storing. See page 26 for clean-
ing instructions. Store on level, solid ground.
2. Disconnect driveline and secure up off the ground.
3. Lower wings to ground.
4. Raise cutter center section and pin transport bar in
raised position.
5. Attach parking jack and raise tongue weight off trac-
tor drawbar.
6. Place wedge blocks at front and rear of wheels
on center section and each wing to prevent wheel
rotation.
7. Securely block all four corners of center section and
each wing with jack stands.
8. Remove hydraulic hoses after tractor is turned off
and all system pressure is released by operating
valve levers several times.
9. Remove safety tow chain from tractor.
10. Remove retainer pin and high strength drawbar pin.
11. Keep children, bystanders, and animals away from
equipment and the storage area.
MAN1282
( 04/18/23 )
4/18/23 2:54 PM 4/18/23 2:54 PM