Pre-Operation Checklist - Woods BATWING BW20.51Q Operator's Manual

PRE-OPERATION CHECKLIST

(OWNER'S RESPONSIBILITY)
Review and follow all safety rules and safety de-
cal instructions on page 7 through page 13.
Check that all safety decals are installed and in
good condition. Replace if damaged or illegible.
Check that equipment is properly and securely
attached to tractor.
Make sure driveline spring-activated locking pin
or collar slides freely and is seated firmly in trac-
tor PTO spline groove.
Check all lubrication points and grease as in-
structed in lubrication information. Make sure the
PTO slip joint is lubricated and that the gearbox
fluid levels are correct.
Set tractor PTO at correct RPM for your
equipment.
Check that all hydraulic hoses and fittings are in
good condition and not leaking before starting
tractor. Check that hoses are not twisted, bent
sharply, kinked, frayed, or pulled tight. Replace
any damaged hoses immediately.
Check that all hardware is properly installed and
secured.
Check cutting height and attitude adjustment.
MAN1282
( 04/18/23 )
MAN1282_2023-04.indd 19 MAN1282_2023-04.indd 19
Raise and lower equipment to make sure air is
purged from hydraulic cylinders and hoses.
Check that blades are sharp and secure and
cutting edge is positioned to lead with correct
rotation.
Make sure tractor ROPS or ROPS cab and seat
belt are in good condition. Keep seat belt secure-
ly fastened during operation.
Check that shields and guards are proper-
ly installed and in good condition. Replace if
damaged.
Before starting engine, operator must be in
tractor seat with seat belt fastened. Place trans-
mission in neutral or park, engage brake and
disengage tractor PTO.
Inspect area to be cut and remove stones,
branches, or other hard objects that might be
thrown and cause injury or damage.
Inspect chain shielding and replace any dam-
aged or missing links.
Make sure tractor 3-point lift links do not interfere
with hydraulic hoses or driveline throughout full
turning range.
Check the tire pressure for pneumatic tires. The
maximum pressure allowed is 40 psi.
Operation 19
4/18/23 2:54 PM 4/18/23 2:54 PM