System Options - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

System options

Meridian 1 Option 61C CP PII and Succession 1000M
Single Group
The procedures in this document apply to the following system options:
• Meridian 1 Option 61C CP PII: enhanced common control complex with
dual CPU, full network group
• Meridian 1 Option 81C CP PII: enhanced common control complex with
dual CPU, multiple network groups
• Succession 1000M Single Group: a Meridian 1 Option 61C CP PII
system upgraded to include a Signaling Server (see note below)
• Succession 1000M Multi Group: a Meridian 1 Option 81C CP PII
system upgraded to include a Signaling Server (see note below)
Note: For information about Succession Signaling Server installation
and configuration, see Signaling Server: Installation and Configuration
(553-3001-212).
All system options are available in both ac- and dc-powered versions.
System architecture and module types are described in Large System:
Overview (553-3021-010). The components of ac-powered systems,
dc-powered systems, and reserve power options for both are described in this
document.
These systems feature a dual Pentium II Processor with standby processing
capability, fully redundant memory, and a full network group. Two Core/Net
modules and one IPE module are the minimum installation requirements.
Additional IPE modules and application modules can be used. The modules
are stacked (see Figure 5 on
on page 28).
Preparing for installation
page 28) or installed side-by-side (see Figure 6
Large System Installation and Configuration
Page 27 of 376