Table of Contents
Advertisement
CHAPTER 1
WELCOME
No.
Name
1
Standby
2
Select
3
Mute
4
Decrease
5
Increase
IMPORTANT
If there is a film over the front control panel, remove it before using the front control panel.
In normal operation, all buttons are white.
The Standby button also functions as an indicator light:
Indicator light
Status
Solid white
Normal operation
Off
Not receiving power
Solid amber
DPMS (power
management) mode
Slowly flashing
Standby mode
amber
Flashing amber
No USB connection from
the connected computer
7
smarttech.com/kb/171166
Procedure
Press to enter or exit Standby mode.
l
Press and hold to reset the display.
l
Press to switch inputs.
Press to mute or unmute the volume.
l
Press and hold to freeze and unfreeze the screen (see
l
page 18).
Press to decrease the volume.
Press to increase the volume.
Procedure
l
l
l
l
l
l
l
l
l
[N/A]
Confirm the display's power cable is
connected to the power outlet.
Flick the switch beside the AC power inlet
to the ON (I) position.
Press the Standby button
DPMS mode.
Connect an input source.
Press the Standby button
Standby mode.
If presence detection is enabled, move in
range of the presence detection sensor.
If Wake to Touch is enabled, touch the
screen.
Verify the connections to the computer.
Switch to the computer's input.
See Using SMART software on connected
computers on page 14.
to exit
to exit
Advertisement
Table of Contents
