CDA CD 9002/1 SS Operating Instructions Manual page 8

Electronic clock
The programmer is equipped with an
electronic clock with lighted numbers
which indicate hours and minutes.
Upon immediate connection of the oven
or after a blackout, three zeroes will flash
on the programmer panel.
To set the hour it is necessary to push the
button and then the
button until you have set the exact hour
(fig. 5).
Alternatively, simultaneously push the
two buttons and at the same time
push the or
Note: Setting the clock deletes any
programme.
Normal cooking without
the use of the
programmer
To manually use the oven, that is, without the
aid of the programmer, it is necessary to
cancel the flashing AUTO by pushing the
button (AUTO will be switched off and
the symbol will go on - Fig. 6).
Attention: If the AUTO is not flashing (which
means a cooking program has already been
inserted), by pushing the button
have cancelled the programme and
switched to manual.
Fig. 6
8
(fig. 5)
or
button.
Electronic timer
The timer programme consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO is flashing push the
button.
To set the time, push the
the
desired time (fig. 7).
Having finished the setting, the normal
time will appear on the panel and the
symbol will appear.
The countdown will start immediately
and may be seen at any moment on the
panel by simply pressing the button
At the end of the time, the
will be switched off and an intermittent
buzzer will go off; this can be stopped
by pressing any one of the buttons.
Altering the audible
signal
By pressing the
choose from three variations.
you
Fig. 7
or until you obtain the
button you can
A
U
T
O
button and
.
symbol