Advertisement
2.1
Transport mode
2.2
Diagnostics connector
2.3
Unpacking and setting up the vehicle
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
H02712-01
handing it over to the customer.
Diagnostics connector
control unit.
H00933-12
Condition
Packaging V2
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling
over. To avoid damaging the motorcycle during the
setup, leave the protective film on the vehicle until
you have finished.
E00851-10
–
Remove the separate enclosure and unpack it. Check that
the scope of supply is complete using the enclosed pack-
ing list.
Info
The procedure for missing components is described
in the Customer Service Manual.
–
Have a lift stand available.
Lift stand (78129955100)
–
Carefully loosen and remove the tension belt of the footrest
mount.
1
is located under the seat below the EFI
SETUP 2
3
Advertisement
