3 WORK
3.23
3.24
36
E00899-11
Checking the headlight setting
400726-10
Adjusting the headlight range
V00369-10
–
Position the headlight mask and secure it with rubber
2
straps
.
The holding lugs engage in the fender.
–
Position the brake line and wiring harness in the brake line
guide.
Finishing work
–
Check the headlight setting. (
–
Park the vehicle on a horizontal surface in front of a light-
colored wall and make a mark at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider.
»
If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
1
Loosen screw
.
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider (instructions on how
to apply the mark: Checking the headlight setting).
p. 36)
B
under the first marking.
5 cm (2 in)
A
away from the
5 m (16 ft)
p. 36)
p. 36)