KTM 250 EXC TPI 2022 Setup Instructions page 27

3.9 Installing the fork legs
Main work
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB
(red adjuster). The compression damping is located in
left fork leg COMP (white adjuster).
Grooves are milled into the side of the upper end of the
S04824-13
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
(All standard models)
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
S04894-11
triple clamp
(All special models)
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
S04893-11
triple clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
E00375-11
Finishing work
–
Install the front wheel. (
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
1
are positioned toward the front.
2
.
M8 20 Nm
(14.8 lbf ft)
3
.
M8 15 Nm
(11.1 lbf ft)
2
.
M8 17 Nm
(12.5 lbf ft)
3
.
M8 15 Nm
(11.1 lbf ft)
M8 25 Nm (18.4 lbf ft)
5
.
p. 26)
p. 36)
WORK 3
4
.
Loctite ® 243™
p. 35)
25