Home Connect - NEFF B6ACM7AG0A User Manual And Installation Instructions

Display Basic setting
Brightness of the display illumination
Time display
Childproof lock can be adjusted
→ "Childproof lock", Page 13
Interior lighting during operation
Cooling fan run-on time
Telescopic shelves retrofitted
Sabbath mode available
→ "Sabbath mode", Page 14
Automatic rapid heating from 200 °C
Reset all values to factory settings
.. Home Connect Settings
Factory setting (may vary according to model)
1
Depending on the appliance specifications
2
13.2 Changing basic settings
Requirement: The appliance is switched off.
1.
Press and hold the ⁠ button for approximately
four seconds.
a The first basic setting appears in the display, e.g. ⁠
⁠ ⁠ ⁠ .
2.
Use the temperature selector to change the setting.
3. Use the ⁠ or ⁠ button to switch to the next basic set-
ting.
14 Home Connect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the Home Connect app, adjust its basic settings
and monitor its operating status.
The Home Connect services are not available in every
country. The availability of the Home Connect function
depends on the availability of Home Connect services
in your country. You can find information about this at:
www.home-connect.com.
The Home Connect app guides you through the entire
login process. Follow the instructions in the Home Con-
nect app to configure the settings.
Tips
¡ Please consult the documents supplied by
Home Connect.
¡ Please also follow the instructions in the Home Con-
nect app.
Selection
= dark
= medium
= bright
= hide the time
= display the time
= no
= yes
= yes, with locked door
= no
= yes
= short
= medium
= long
= extra long
2
= no
= yes (for 2- and 3-level pull-out)
= no
= yes
2
= no
= yes
= no
= yes
→ "Home Connect ", Page 15
4.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
13.3 Discarding changes to the basic
settings
▶
a All changes are discarded and not saved.
Notes
¡ Please note the safety precautions in this instruction
¡ Operating the appliance on the appliance itself al-
¡ In networked standby mode, the appliance requires
1
1
1
1
1
1
(for rails and 1-level pull-out)
1
1
1
To save the changes, press and hold the ⁠ button
for approx. four seconds.
Turn the function selector.
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
a maximum of 2 W.
Home Connect en
15