Electrolux W585S Service Manual page 81

13:4 INNER DOOR JACK POSITION
Machine indicates that the inner door opening jack is not in home position when the drum is rotating.
The error code is shown if input JACK AT HOME is not active when the reported motor speed is not zero.
Recommended actions:
1. Check functionality for JACK, i.e that it is in backwards position when expected.
2. Check functionality JACK_AT_HOME sensor DP6, i.e active when jack is in backward position, inactive when
JACK is in forward position.
3. Check wiring to JACK_AT_HOME sensor DP6, bad contact in the sensor could cause this problem.
13:5 DOOR UNLOCKING
Machine indicates that either loading or unloading door is not able to unlock.
The error code is shown if inputs LOADING DOOR LOCKED or UNLOADING DOOR LOCKED does not get inactive
within a resonable time after door unlock command is sent.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by monitoring input and output
status under Check inputs and outputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
13:6 DRUM LOCK POSITION SWITCH
The error code is shown if inputs DRUM UNLOCKED and DRUM LOCKED are both active or inactive at the same
time during program run. Since it occurs during program run it is required to turn power off to the machine to clear the
error message.
Possible causes:
Heavy unbalance in drum that prevents the motor to position the drum. Worst case scenario is wet load in one
compartment.
Could also depend on problems with indexing sensors, washer I/O board or malfunction in mechanical drum lock
function.
Recommended actions:
1. Check inputs from indexing sensors FC1 and FC2.
2. Run a positioning sequence with wet load in one compartment to test functionality.
13:7 DRUM NOT ROTATING
The error code is shown if positioning sensor on input on J201 is not indicating rotation when rotation is expected
during program run.
Recommended actions:
1. Check that drive belt is not broken.
2. Check positioning sensor on input J201.
13:8 UNBALANCE SWITCH ON AT PROG START
The error code is shown if unbalance switch is active at program start.
Recommended actions:
1. Check unbalance switch for proper alignment.
2. Check unbalance switch for electrical fault.
13:9 WATER IN DRUM - CALL SERVICE
This error code will be shown if the control system detects water above safety level when program is finished.
Possibly caused by broken inlet valve and / or drain valve.
Recommended actions:
1. Turn off water inlet to machine.
2. Manually open the drain valve.
3. Check reason for valve malfunction.
Service Manual
81