12.2 Replacement of I/O module
I/O module type 1, 11 or 3
I/O module type 1, 11 or 3 are installed in the same way.
Disconnect the power to the machine.
Demount the top panel.
Remove the cover on the module.
Remove the electrical connections on the module. (Note the position of the connections).
Remove the module by pulling it upwards.
Insert the new module and make sure it is in position.
Connect the electrical connections in the same way as before.
Mount the cover.
Remount the top panel.
Connect the power to the machine.
Service Manual
53
fig.7798
fig.7799