Mount the third sealing. The lip shall lay against the housing. Don't push too far as the lip can break.
Thread the shaft end with M10 and min 20 mm deep.
Mount the bearing housing to the rear gable and tighten the bolt crosswise.
Note!
The marking (up) shall be pointing upwards when rear gable is in place on the machine.
Mount the rear gable over the drum shaft. Be sure to put it on horizontally so that the sealings don't get damaged on
the shaft.
Mount the adaptor on the shaft end and thread it down to the bottom.
Service Manual
33
fig.7057
fig.7058
fig.7059