Autostop Mode; Possible Reasons The Engine Does Not Autostop; To Start The Engine While In Autostop Mode; To Manually Turn Off The Stop/Start System - Jeep WRANGLER 2024 Owner's Manual

Table of Contents

Advertisement

170
STARTING AND OPERATING

AUTOSTOP MODE

WARNING!
Vehicles with the Stop/Start system will be equipped
with two batteries. Both the main and the supple-
mental batteries must be disconnected to completely
de-energize the 12 Volt electrical system.
Serious injury or death could result if you do not
disconnect both batteries. To learn how to properly
disconnect, see an authorized dealer.
The Stop/Start feature is enabled after every driver igni-
tion start. It will remain in STOP/START NOT READY until
you drive forward with a vehicle speed greater than
5 mph (8 km/h). At that time, the system will go into
STOP/START READY and if all other conditions are met,
can go into an STOP/START AUTO STOP ACTIVE mode.
To Activate The STOP/START AUTOSTOP ACTIVE Mode,
The Following Must Occur:
The system must be in STOP/START READY state. A
STOP/START READY message will be displayed in
the instrument cluster
page 124.
Vehicle speed must be less than 2 mph (3 km/h).
The gear selector must be in the NEUTRAL position
and the clutch pedal must be fully released.
POSSIBLE REASONS THE ENGINE
DOES NOT AUTOSTOP
Prior to engine shut down, the system will check many
safety and comfort conditions to see if they are fulfilled.
Situations when the engine will not stop include (but not
limited to):
Driver's seat belt is not buckled.
Outside temperature is less than 10°F (–12°C) or
greater than 109°F (43°C).
Actual cabin temperature is significantly different
than temperature set on Auto HVAC.
HVAC is set to full defrost mode.
Engine has not reached normal operating
temperature.
Battery is discharged.
When driving in REVERSE.
Hood is open.
Transfer case is in 4L or N (Neutral).
Driver's seat is not occupied or driver's door is open.
Vehicle is at high altitude.
The vehicle is on a steep grade.
Forward Gear is engaged.
Steering angle is beyond threshold (ESS Models Only).
System fault is present.
HVAC is set to MAX A/C.
It may be possible for the vehicle to be driven several
times without the Stop/Start system going into a STOP/
START READY state under more extreme conditions of
the previously listed items.
TO START THE ENGINE WHILE IN
AUTOSTOP MODE
When the gear selector is in NEUTRAL, the engine will
start when the clutch pedal is pressed (does not
require complete/full pedal press). The vehicle will go
into STOP/START SYSTEM NOT READY mode until the
vehicle speed is greater than 5 mph (8 km/h).
Conditions that will cause the engine to start automati-
cally while in STOP/START AUTOSTOP ACTIVE mode
The Engine Will Start Automatically When:
Actual cabin temperature is significantly different
than temperature set on Auto HVAC.
HVAC is set to full defrost mode.
HVAC system temperature or fan speed is manually
adjusted higher.
Stop/Start Autostop Active time exceeds five minutes.
Battery voltage drops too low.
Vehicle is moving faster than 5 mph (8 km/h).
STOP/START OFF switch is pressed.
Transfer case is in 4L or N (Neutral).
Steering wheel is turned beyond threshold (ESS
Models Only).
TO MANUALLY TURN OFF THE
STOP/START SYSTEM
1. Push the Stop/Start OFF switch (located on the
switch bank). The light on the switch will illuminate.
Stop/Start OFF Switch

Advertisement

Table of Contents
loading

Table of Contents