Manual Park Release - Jeep WRANGLER 2024 Owner's Manual

Table of Contents

Advertisement

278
IN CASE OF EMERGENCY
If the temperature gauge is moving towards or close to
the HOT (H) position, you can reduce the potential for
overheating by taking the appropriate action.
On highways — slow down.
In city traffic — while stopped, place the transmis-
sion in NEUTRAL (N), but do not increase the engine
idle speed while preventing vehicle motion with the
brakes.
Turn the Air Conditioner (A/C) off. The A/C system
adds heat to the engine cooling system and turning
the A/C off can help remove this heat.
Turn the temperature control to maximum heat, and
the blower control to high. This allows the heater
core to act as a supplement to the radiator and aids
in removing heat from the engine cooling system.
CAUTION!
Driving with a hot cooling system could damage your
vehicle. If the temperature gauge reads HOT (H), pull
over and stop the vehicle. Idle the vehicle with the air
conditioner turned off until the pointer drops back
into the normal range. If the pointer remains on HOT
(H), and you hear continuous chimes, turn the engine
off immediately and call for service.

MANUAL PARK RELEASE

In order to move the vehicle in cases where the trans-
mission will not shift out of PARK (P) (such as a
depleted battery), a Manual Park Release is available.
WARNING!
Always secure your vehicle by fully applying the park-
ing brake before activating the Manual Park Release.
In addition, you should be seated in the driver's seat
with your foot firmly on the brake pedal when activat-
ing the Manual Park Release. Activating the Manual
Park Release will allow your vehicle to roll away if it is
not secured by the parking brake, or by proper con-
nection to a tow vehicle. Activating the Manual Park
Release on an unsecured vehicle could lead to seri-
ous injury or death for those in or around the vehicle.
See the following steps to use the Manual Park
Release:
1. Firmly apply the parking brake.
2. Using a small screwdriver or similar tool, remove the
manual park release cover located in front of the
gear selector, to access the release tether strap.
Manual Park Release Cover
3. Fish the tether strap up through the opening in the
console base.
Tether Strap
4. Press and maintain firm pressure on the brake
pedal.
5. Pull the tether strap up until the release lever locks
into place in the vertical position. The vehicle is now
out of PARK (P) and can be moved. Release the
parking brake only when the vehicle is securely con-
nected to a tow vehicle.

Advertisement

Table of Contents
loading

Table of Contents