Trailcam System - If Equipped - Jeep WRANGLER 2024 Owner's Manual

Table of Contents

Advertisement

When the vehicle is shifted out of REVERSE with Cam-
era delay turned on, the rear Camera image will be dis-
played for up to 10 seconds unless the vehicle speed
exceeds 8 mph (13 km/h), the transmission is shifted
into PARK, the ignition is placed in the OFF position, or
the touchscreen X button to disable display of the Rear
View Camera image is pressed.
Whenever the Rear View Camera image is activated
through the Back Up Camera button in the Controls
menu, and the vehicle speed is greater than, or equal
to, 8 mph (13 km/h), a display timer for the image is
initiated. The image will continue to be displayed until
the display timer exceeds 10 seconds.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image will be dis-
played continuously until deactivated via the touch-
screen X button, the transmission is shifted into
PARK, or the ignition is placed in the OFF position.
The touchscreen X button to disable display of the
camera image is made available ONLY when the
vehicle is not in REVERSE.
When enabled, active guidelines are overlaid on the
image to illustrate the width of the vehicle and its pro-
jected back up path based on the steering wheel position.
A dashed center line overlay indicates the center of the
vehicle to assist with parking or aligning to a
hitch/receiver.
When enabled, fixed guidelines are overlaid on the
image to illustrate the width of the vehicle.
Different colored zones indicate the distance to the rear
of the vehicle.
The following table shows the approximate distances
for each zone:
Distance To The Rear Of
Zone
The Vehicle
Red
0 - 1 ft (0 - 30 cm)
Yellow
1 ft - 6.5 ft (30 cm - 2 m)
6.5 ft or greater
Green
(2 m or greater)
WARNING!
Drivers must be careful when backing up even when
using the ParkView Rear Back Up Camera. Always
check carefully behind your vehicle, and be sure to
check for pedestrians, animals, other vehicles,
obstructions, or blind spots before backing up. You
are responsible for the safety of your surroundings
and must continue to pay attention while backing up.
Failure to do so can result in serious injury or death.
CAUTION!
To avoid vehicle damage, ParkView should only be
used as a parking aid. The ParkView camera is
unable to view every obstacle or object in your
drive path. You remain responsible at all times for
parking safely while using the ParkView camera.
To avoid vehicle damage, the vehicle must be
driven slowly when using ParkView to be able to
stop in time when an obstacle is seen. It is recom-
mended that the driver look frequently over his/
her shoulder when using ParkView.
STARTING AND OPERATING
NOTE:
If snow, ice, mud, or any foreign substance builds up on
the camera lens, clean the lens, rinse with water, and
dry with a soft cloth. Do not cover the lens.
TRAILCAM SYSTEM — IF EQUIPPED
Your vehicle may be equipped with a TrailCam that
allows you to see an on-screen image of the front view
of your vehicle. The image will be displayed on the
touchscreen display along with a caution note "Check
Entire Surroundings" across the top of the screen.
When enabled, active dynamic tire lines are projected
on the ground plane of the TrailCam view based on the
steering wheel position.
Front View Camera
NOTE:
The system will stay active while in 4WD Low.
The TrailCam system has programmable settings that
may be selected through the Uconnect system
page 201.
183
4

Advertisement

Table of Contents
loading

Table of Contents