Charge Information; Battery Recommendations - Honeywell Voyager XP 147 Series User Manual

Charge Information

The battery is designed to charge while the scanner is positioned in the cordless
base unit. Refer to
pretation of the Charge Status indicators. Refer to
charge a scanner without linking it to the base.
Place the scanner in the base that is connected to an appropriate power supply.
Use only a Listed Limited Power Source (LPS) or Class 2 type power supply with
output rated 5 to 5.2Vdc, 1A.
Note: If you are powering the base through the interface cable (for example, a USB cable)
and not using an external power supply plugged into the aux port, the current
available for charging is reduced and charge times are increased.

Battery Recommendations

•
•
•
•
•
Caution: Use only Honeywell Li-ion battery packs, model number BAT-
Safety Precautions for Lithium Batteries
•
•
•
•
•
•
42
Base/Access Point LED Sequences and
The battery is a lithium ion cell and can be used without a full charge, and can
also be charged without fully discharging, without impacting the battery life.
There is no need to perform any charge/discharge conditioning on this type of
battery.
Keep the base connected to power when the host is not in use.
Replace a defective battery immediately since it could damage the scanner.
Although your battery can be recharged many times, it will eventually be
depleted. Replace it after the battery is unable to hold an adequate charge.
If you are not sure if the battery or charger is working properly, send it to
Honeywell International Inc. or an authorized service center for inspection.
Refer to Customer Support
SCN01, rated 3.7 Vdc, 7.4Whr in this device. Use of any non-
Honeywell battery may result in damage not covered by the
warranty.
Do not place batteries in fire or heat the batteries.
Do not store batteries near fire or other high temperature locations.
Do not store or carry batteries together with metal objects.
Do not expose batteries to water or allow the batteries to get wet.
Do not connect (short) the positive and negative terminals, of the batteries, to
each other with any metal object.
Do not pierce, strike or step on batteries or subject batteries to strong impacts or
shocks.
Charge Only Mode
for additional information.
Meaning, for an inter-
if you need to
Voyager XP User Guide