Waste Water Tray; Transport Condition; Empty Air Break; Power Off - Jetinno JL18 Service Manual

Table of Contents

Advertisement

1)
Pull out the residue bin forward
2)
Empty the residue bin and clean
3)
Dry the residue bin, then push back into the machine to the bottom
4)
Machine ready to operate.

4.6.2 Waste water tray

Pull out the waste water tray outward
Make sure no drinks come out before removing the waste water tray
Make sure that the waste water detected sensor is in the waste water tray when installing

4.7 Transport condition

Improper transportation of coffee machines may result in injuries
Attention to General Health and Safety Notice
Be sure to disconnect the drinking water source and power supply ,and empty the air break
1)
before changing position
2)
Check the ground if there are obstacles and unevenness before changing position

4.8 Empty air break

Refer to previous section5.4.33
Improper transportation may cause damage to machines when using stackers to transport machines
Attention to the following points when using handcart to change the position of the machine
Considering safety, do not push the handcart when changing position, only drag
Can only drag handcart, not machine。
The manufacturer is not responsible for any damage caused by misuse of the handcart or failed to
comply with the instructions

4.9 Power off

4.9.1 End operation

Standby mode
49

Advertisement

Table of Contents
loading

Table of Contents